Instruction Manual for Canon 10D:
Mounting and Detaching a Lens
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
Mounting a Lens...
Remove the caps......
Attach the lens......
Remove the rear lens cap and the body cap by turning them as shown by the arrow......
Align the red dots on the lens and camera and turn the lens as shown by the arrow until it snaps in place......
Lens mount index...
On the lens, set the focus mode switch to < AF......
If the focus mode switch is set to < MF > (or < M > on older lenses), autofocus will not operate......
 |
Instruction Manual for Canon 10DUsers also looked at:
The color space indicates the color reproduction range...The camera is compatible with the sRGB and Adobe RGB color spaces......
Set the lens focus mode switch to < MF > (or < M > on older lenses......
In such cases, do one of the following: 1...2...p.27...
Autofocus can fail to achieve focus (the focus confirmation light blinks) with certain subjects such as the following: (a) Low-contrast subjects (blue sky, solid-color walls, etc...c) Extremely backlit reflective subjects (car with a reflective body, etc...d) Overlapping near and far objects (animal in a cage, etc......
Center-weighted average metering...
Drive mode...
Single frame...
Manual Focusing...
Focus by turning the lens focusing ring until the subject is in focus in the viewfinder......
If you press the shutter button halfway during manual focusing, the active AF point and the focus confirmation light <●> in the viewfinder will light when focus is achieved...An off-center AF point may not be able to achieve focus...With USM (Ultrasonic Motor) lenses (except those not having a distance scale), you can use the focusing ring to fine focus after focus is achieved in the One-Shot AF mode (full-time manual focusing......
|