Instruction Manual for Canon 10D:
Changing the Review Time
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
You can set the image review time to [2 sec.], [4 sec.], [8 sec.], or [Hold] which keeps the image displayed on the LCD monitor......
On the menu, select [Review time......
Press the < > button...Turn the < > dial to select [Review time], then...press...
Set the Review time setting......
Turn the < > dial to select the desired setting...then press...
The [Hold] setting keeps displaying the image until you press the shutter button halfway...For continuous shooting, the [Review time] will apply to the last shot...Then press < To view images captured previously, see “Playback Images.” (→p.107...
 |
Instruction Manual for Canon 10DUsers also looked at:
Use this mode to take close-up shots of flowers, insects, etc...To obtain a larger magnification, use the telephoto end of a zoom lens...The < > AF mode, < > (single) drive mode, > metering mode, “ ” ISO speed, and < > < white balance will be set automatically......
Programmed Image Control Modes...
may continue blinking for a few seconds while the CF card records the image......
Set to this position when the camera is in use...The camera does not operate...Set to this position when not using the camera......
After the image is recorded in the CF card, the access lamp will turn off and the camera will turn off......
The blinking frequency of the red lamp indicates the progress of the recharging......
Connect the power cord to the charger...Connect the power plug to an AC outlet......
reverse......
recharging starts automatically and the red lamp starts blinking......
s A completely exhausted battery takes about 90...
minutes to almost fully recharge......
s After the battery recharging is almost com...
Recharge the battery......
Store the cover in a place where it will not be lost...If you remove the battery from the camera, be sure to reattach the cover to protect against short circuit......
|