Instruction Manual for Canon 10D:
Switching to the Registered AF Point
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
Normally, to switch to the registered AF point, you press the < > button and < > button simultaneously...However, with C.Fn-13-1/2, you can just press the < > button to switch to the registered AF point......
Press the < > button and < simultaneously......
This is the default method with C.Fn-13-0......
For the setting procedure, see “Setting Custom Functions” (→p.145) or see page 69......
button to switch to Press only the < the registered AF point......
 |
Instruction Manual for Canon 10DUsers also looked at:
FE (flash exposure) Lock obtains and locks the correct flash exposure reading for any part of a subject...FE Lock is a function in the Creative zone......
icon lights in the viewfinder......
s The center AF point will flash in red...s In the viewfinder, the display appears as shown in...
If the subject is too far away and beyond the effective range of the flash, the < will blink...Get closer to the subject and repeat steps 2 to 4......
Press the < > button to pop-up the built-in flash...In the viewfinder, check that the < > icon is lit......
Check that the < > icon is lit......
then...
Spot metering circle...
button...p.150...
required flash output for this subject in memory......
icon...
Focus on the subject you want to lock the flash exposure on......
s The Speedlite fires a preflash and records the...
Aim the partial metering circle over the subject where you want to lock the flash exposure press the < > button......
|