Instruction Manual for Canon 10D:
Recharging the Battery
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
Connect the power cord......
Connect the power cord to the charger...Connect the power plug to an AC outlet......
Remove the cover......
Store the cover in a place where it will not be lost...If you remove the battery from the camera, be sure to reattach the cover to protect against short circuit......
mark...
Attach the battery......
Align the battery’s top edge with the < – > mark on the charger...While pressing down the battery, slide it in the direction of the arrow......
 |
Instruction Manual for Canon 10DUsers also looked at:
1/3-stop increments...p.147...
Shutter-Priority AE...
In the shutter-priority AE mode, if a correct exposure cannot be obtained with any aperture set by the camera, the camera automatically sets a faster or slower shutter speed...This feature is called safety shift......
With C.Fn-06-1,you can also set the camera so that you can set the shutter speed in...
Fast shuter speed Slow shuter speed...
If the aperture value is not blinking, the exposure is correct...Compose the shot, then press the shutter button down fully......
Press the shutter button down halfway......
If the lens’ maximum aperture (lowest f/number like f/3.5) blinks, it indicates underex...
Turn the < > dial to set the desired shutter speed......
C.Fn-16-1 enables the safety shift feature...p.151...
Check the display, then shoot......
You can set the shutter speed in half-stop increments as shown below...The shutter speeds from “ ” to “ ” indicate the denominator of the fractional shutter speed, so that— for example— “ ” is 1/125 second...For slow speeds, “ ” is 0.7 seconds and “ ” is 15 seconds......
|