Instruction Manual for Canon 10D:
Drive Mode Selection
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
Single frame: Only one shot is taken when you press the shutter button......
Continuous shots are taken while you hold down the shutter button fully......
The self-timer starts when you press the shutter button fully...later...p.77...
Continuous Shooting Speed...
One Shot AF AI Servo AF...
Approx...3 fps...
Maximum Burst...
Approx...9 shots...
mode, the above figures will apply regardless of the C.Fn-08 setting......
 |
Instruction Manual for Canon 10DUsers also looked at:
To BJ printer...
To connect the camera and printer with the necessary cable, refer to the manuals that came with the printer......
s LCD...
Follow steps 1 to 3 in “Connecting to a Card Photo Printer” to connect the camera to the BJ printer...p.123...
icon will appear on the printer’s operation panel......
When disconnecting the cable from the camera’s < > terminal, be sure to grasp the plug instead of the cord to pull it out...Do not use any cable other than the dedicated interface cable to connect the camera and printer......
BJ printer-connected icon...
To disconnect the cable from the camera and printer, follow the procedure below: 1...3...Even while the camera is connected to the printer, you can instantly switch to shooting by pressing the shutter button halfway (except during actual printing......
Press the printer’s power button to turn it on......
|