User Guide for Canon D60:
Automatic Built-in Flash
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
In the Basic Zone (other than < > and < >), the flash pops up automatically and fires in low-light conditions or backlit daylight conditions...Press the flash back down when you are finished using it......
If anything blocks the flash so that it cannot pop up automatically, the error code ” (→135) appears on the LCD panel...When this occurs, set the Main “ Switch to < OFF > and then set it to < ON> again......
 |
User Guide for Canon D60Users also looked at:
File number (→114) Histogram Exposure compensation (→77) Flash exposure compensation (→91) (not...
For settings displayed while preparing to shoot, see “Checking Camera...
Darker image Normal brightness Lighter image...
When exposure information is displayed for a picture that will be overexposed, the related settings will blink...For better results check the histogram and adjust the exposure compensa- tion towards the decreased exposure end (→77), then take the picture again......
Image protect (→103) Date (→34) Time (→34) Quality (→50...
Image Information Displayed During PLAY...
Settings” (→60......
LCD monitor information display On and Off......
ISO speed (→51) Metering mode (→61) White balance (→64...
Image (→40...
displayed when flash not in use...
The histogram is a graph showing brightness levels on the horizontal axis, and the number of pixels at each level of brightness on the vertical axis...Darker pixels are towards the left side of the graph, and brighter pixels towards the right...By looking at a histogram you can judge the brightness of a picture after it is recorded......
|