User Guide for Panasonic AW-PH500:
∫When using the RS-232C interface and control panel to
This document also applies to:
Chapter Summary:
control the pan/tilt head...
Max...distance of 500 meters (when extended) between pan/tilt head and controller (monitor, G/L source...
To extend the cable to a length exceeding 15 meters, convert the interface from RS-232C to RS-422 for sending, and convert it back to RS-232C at the receiving end......
Refer to the connections with the PC in the section entitled “When using the RS-232C interface to control the pan/tilt head...
|
|
User Guide for Panasonic AW-PH500
Users also looked at:
3...Return the panel to its original position, and anchor...
it using the screws...Fasten the panel securely...
to the panel to ON......
Use the rotary arm anchoring screws (a8, supplied), rotary arm anchoring flat washers (a8, supplied) and rotary arm anchoring springwashers (a8, supplied) to attach the rotary arm (supplied) to the pan/tilt head...Tighten up the screws securely to prevent the arm from coming loose during use......
Rotary arm anchoring Flat washer (a8...
2...Set the switch on the printed circuit board attached...
Rotary arm anchoring Spring washer (a8...
Rotary arm anchoring screws (a8...
Screws (a6...
Attaching the rotary arm...
A maximum length of up to 500 meters is allowed for the cables (including the video camera control cable) between the pan/tilt head and controller when the 5C-2V cables are used...However, if the cable length is to exceed 300 meters, set the cable compensation circuit to ON by following the steps below......
|
This "User Guide" also applies to the following products:
