User Guide for Panasonic AW-PH500:
Overview
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
This stand-alone indoor pan/tilt head for ENG applications enables the camera to be turned 95 degrees upward, 95...
degrees downward and 300 degrees on the horizontal......
A total weight of 15 kg including the camera and lens can be supported...Direct control can be exercised from the AW-RP301 pan-tilt control panel...However, the camera itself cannot be controlled...
from the panel......
The pan/tilt head can be controlled directly from the AW-RP501 hybrid control panel...When the AW-RP305 multi-control panel or AW-RP505 multi-hybrid control panel is used, up to five pan/tilt heads can be...
 |
User Guide for Panasonic AW-PH500Users also looked at:
Circuit board for cable compensation circuit...
1...Remove the six screws on the side opposite to the...
Rotary arm anchoring Flat washer (a8...
Rotary arm...
OFF...
Attaching the rotary arm...
Rotary arm anchoring Spring washer (a8...
A maximum length of up to 500 meters is allowed for the cables (including the video camera control cable) between the pan/tilt head and controller when the 5C-2V cables are used...However, if the cable length is to exceed 300 meters, set the cable compensation circuit to ON by following the steps below......
ON...
Attaching the pan/tilt head...
3...Return the panel to its original position, and anchor...
to the panel to ON......
Use the rotary arm anchoring screws (a8, supplied), rotary arm anchoring flat washers (a8, supplied) and rotary arm anchoring springwashers (a8, supplied) to attach the rotary arm (supplied) to the pan/tilt head...Tighten up the screws securely to prevent the arm from coming loose during use......
2...Set the switch on the printed circuit board attached...
Setting the cable compensation circuit...
it using the screws...Fasten the panel securely...
connector panel of the pan/tilt head pedestal, and pull the panel out toward you......
Rotary arm anchoring screws (a8...
|