User Guide for Panasonic AW-PH500:
∫How to replace the battery
This document also applies to:
Chapter Summary:
1...Remove the panel by removing the six screws on...
the side opposite to the one with the rotary arm......
2...Remove the two screws shown in the figure on the...
right, and draw out the circuit board......
Screws (a2...
3...Pull down the battery to remove it, and then install a...
replacement battery......
Battery...
|
|
User Guide for Panasonic AW-PH500
Users also looked at:
VIDEO IN connector (BNC...
The video camera control cable is connected to this connector...Refer to the section entitled “Connections...
8 Lens I/F connector (12-pin round...
The ENG camera is mounted on this arm...The arm rotates in the tilting direction......
5 Tally lamp...
This output connector is used to perform ON/OFF control for the motorized ND filter, the ND filter of a lens with a built-in motorized extender and the lens extender...The R03-P6M or R03- PB6M connector made by Tajimi Electronics Co., Ltd...ND signal B : ND return F A C : EXT signal D : EXT return B E E : GND F : VCC (+15 V) D C...
The G/L signals sent from the controller are output from this connector which is connected to the G/L input connector on the camera......
|
This "User Guide" also applies to the following products:
