Instruction Manual for Canon ZR90:
End Search
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
When you have played back a tape, you can use this function to locate the end of the last recorded scene......
END SEARCH button...
In stop mode, press the END SEARCH button......
END SEARCH" appears...The camcorder rewinds/fast forwards the tape, plays back the last few seconds of the recording and stops the tape...Pressing the button again cancels the search......
End search cannot be used once you unload the cassette...End search may not work properly if a blank section exists on the tape......
 |
Instruction Manual for Canon ZR80 / ZR85 / ZR90Users also looked at:
automatically, or attempt to close the cover before the cassette compartment has fully retracted......
Be careful not to get your fingers caught in the cassette compartment cover......
If the camcorder is connected to a power source, cassettes can be loaded/ unloaded even if the POWER switch is set to OFF......
1...Slide and hold the OPEN/EJECT switch and open the cassette compartment cover......
out......
Tape protection tab...
Load the cassette with the window facing the grip belt...Unload the cassette by pulling it straight...
Do not interfere with the cassette compartment while it is opening or closing...
Use only videocassettes marked with the D logo......
The cassette compartment opens automatically...
3...Press the P mark on the cassette compartment until it clicks......
4...Wait for the cassette compartment to retract automatically and close the cassette compartment cover......
2...Load/unload the cassette......
Minor discrepancies in the overlapped area can be corrected with the software...You can retake an image by pressing the CARD +/– button to return to the previous...
|