Instruction Manual for Canon ZR90:
Using the Wireless Controller
This document also applies to:
Chapter Summary:
Point it at the camcorder’s remote sensor when you press the buttons......
Inserting Batteries...
The wireless controller operates with two AA (R6) batteries......
1...Open the battery cover......
2...Insert the batteries following the + and – markings......
Replace both batteries......
3...Close the battery cover......
Camcorder and wireless controller are equipped with 2 remote sensor modes...
77...If the wireless controller does not work, check if camcorder and wireless controller are set to the same mode......
|
|
Instruction Manual for Canon ZR80 / ZR85 / ZR90
Users also looked at:
Use a tape recorded in SP, 12-bit mode with this camcorder......
Plays back the original sound...Plays back the added sound......
6...Press the PAUSE a button on the wireless controller to begin dubbing...
AUDIO DUB.” and...
than 3 times......
1...Open the menu and select [AUDIO SETUP...Select [12bit AUDIO], select a setting and close the menu......
Playing Back the Added Sound...
Dubbing...
12bit AUDIO•••STEREO1...
You can select to play back Stereo 1 (original sound), Stereo 2 (added sound), or adjust the balance of both sounds......
You cannot use the DV terminal for audio dubbing...If you add sound to a tape not recorded with this camcorder, sound quality...
Sound quality may decrease when you add sound to the same scene for more...
2...Select [AUDIO DUB.], set it to [AUDIO IN] or [MIC...IN] and close the menu......
Audio device: Stop playback......
the sound via built-in speaker or audio device...You can also connect a TV via S-video terminal...
Speak into the built-in microphone......
However, the mix balance is memorized by the camcorder......
|
This "Instruction Manual" also applies to the following products:
