Instruction Manual for JVC GR-DV5000AG:
Random Assemble Editing [R.A.Edit]
This document also applies to:
Chapter Summary:
Create edited videos easily using your camcorder as the source player...Before operation, make sure the batteries are installed in the remote control...57...
SHIFT...
MBR SET...
Set Remote/VCR Code...
1 Turn off the power to the VCR and point the...
remote towards the VCR’s infrared sensor...Then, referring to the VCR CODE LIST, press and hold MBR SET, and enter the brand code...The code is automatically set once you release MBR SET, and the VCR’s power comes on......
|
|
Instruction Manual for JVC GR-DV4000 / GR-DV5000
Users also looked at:
When 4/9 is pressed, the image may not...
Pauses during video playback...1) Press 4/9 during playback...2) To resume normal playback, press 4/9 again......
pause immediately while the camcorder stabilises the still image......
If still playback continues for more than about...
3 minutes, the camcorder’s Stop mode is automatically engaged......
the video unit’s Record mode......
sometimes the image may not appear in step 9...If this occurs, turn off the power and make connections again......
To DV IN/OUT...
and recorder are JVC video units, both units will perform the same operation...To prevent this from happening, press the buttons on both units......
5 Turn on the video unit’s power......
To DV IN...
6 Insert the source cassette in this camcorder......
3 Set this camcorder’s VIDEO/MEMORY Switch to...
8 Press 4/9 on this camcorder to start playback of...
Video unit equipped with DV connector...
If a blank portion or disturbed image is played...
|
This "Instruction Manual" also applies to the following products:
