User Guide for Sony CCD-TRV428:
Searching quickly for a desired scene – Zero set memory
This document also applies to:
Chapter Summary:
m REW...
PLAY...
STOP...
DISPLAY...
ZERO SET MEMORY...
During playback, press ZERO SET MEMORY on the Remote Commander at the point you want to locate later on......
The tape counter is reset to “0:00:00” and appears on the screen...If the tape counter is not displayed, press DISPLAY on the Remote Commander......
Press STOP when you want to stop playback......
Press m REW......
The tape stops automatically when the tape counter reaches “0:00:00...
|
|
User Guide for Sony CCD-TRV128 / CCD-TRV228 / CCD-TRV328 / CCD-TRV428 / DCR-TRV260 / DCR-TRV265
Users also looked at:
About the required i.LINK cable...
i.LINK is a more familiar term for the IEEE 1394 data transport bus proposed by Sony, and is a trademark approved by many corporations...IEEE 1394 is an international standard standardized by the Institute of Electrical and Electronics Engineers......
What is i.LINK...
For details on how to dub when this unit is connected to other video device having a DV Interface, see page 62, 63...Before connecting this unit to your computer, make sure that application software supported by this unit is already installed on your computer...For details on precautions and compatible application software, refer also to the operating instructions for the device to be connected......
i.LINK and Corporation......
What is Mbps...Mbps stands for “megabits per second,” or the amount of data that can be sent or received in one second...For example, a baud rate of 100 Mbps means that 100 megabits of data can be sent in one second......
|
This "User Guide" also applies to the following products:
