User Guide for HP J5730: 

Set the fax speed

This document also applies to:


Looking for a manual? Find it here...


Chapter Summary: You can set the fax speed used to communicate between the HP All-in-One and other fax machines when sending and receiving faxes...The default fax speed varies by country/ region...... If you use one of the following, setting the fax speed to a slower speed might be required... An Internet phone service A PBX system Fax over Internet Protocol (FoIP) An integrated services digital network (ISDN) service...


User Guide for HP J5730 / J5740 / J5750 / J5780 / J5785 / J5788

Users also looked at:

The HP All-in-One meets product requirements from regulatory agencies in your country/region......

To clean the print cartridge contacts 1...The print carriage moves to the far right side of the HP All-in-One...Wait until the print carriage is idle and silent, and then unplug the power cord from the back of the HP All-in-One...... Lightly press down on the print cartridge to release it, and then pull it toward you out of the slot...... Clean only the copper-colored contacts...Allow the print cartridges to dry for approximately ten minutes...... Related topics Clean the area around the ink nozzles... Coffee filters are lint-free and work well for cleaning print cartridges...... Inspect the print cartridge contacts for ink and debris buildup...Dip a clean foam rubber swab or lint-free cloth into distilled water, and squeeze any excess water from it...Hold the print cartridge by its sides......

This "User Guide" also applies to the following products: