User Guide for HP J5730: 

Set the fax header

This document also applies to:


Looking for a manual? Find it here...


Chapter Summary: The fax header prints your name and fax number on the top of every fax you send...HP recommends that you set up the fax header by using the software that you installed with the HP All-in-One...You can also set up the fax header from the control panel, as described here...... In some countries/regions the fax header information is a legal requirement...... To set a default fax header from the control panel 1...This selects Basic Fax Setup and then selects Fax Header...Enter your fax number by using the numeric keypad, and then press OK......


User Guide for HP J5730 / J5740 / J5750 / J5780 / J5785 / J5788

Users also looked at:

To set the junk fax mode 1...3...Press... By default, Block Junk Fax mode is turned On...If you do not subscribe to a caller ID service through your phone provider, or do not want to use this feature, you can turn off this setting......

To set up the HP All-in-One with voice mail 1...Using the phone cord supplied in the box with the HP All-in-One, connect one end to your telephone wall jack, then connect the other end to the port labeled 1-LINE on the back of the HP All-in-One...... Figure 4-5 Back view of the HP All-in-One... Turn off the Auto Answer setting...Run a fax test...... If you receive both voice calls and fax calls at the same phone number, and you also subscribe to a voice mail service through your telephone company, set up the HP All-in- One as described in this section......

Tap a stack of paper on a flat surface to align the edges, and then check the paper for the following: • Make sure it is free of rips, dust, wrinkles, and curled or bent edges...Make sure all the paper in the stack is the same size and type...... Insert the stack of paper into the input tray with the short edge forward and the print side down...Slide the stack of paper forward until it stops......

This "User Guide" also applies to the following products: