User Guide for HP J5730:
Avoid paper jams
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
To help avoid paper jams, follow these guidelines......
Remove printed papers from the output tray frequently...Ensure that paper loaded in the input tray lays flat and the edges are not bent or torn...Do not combine different paper types and paper sizes in the input tray; the entire stack of paper in the input tray must be the same size and type......
Adjust the paper-width guide in the input tray to fit snugly against all paper...Use paper types that are recommended for the HP All-in-One...If you load an original in the automatic document feeder while there is already an original on the glass, the original can jam in the automatic document feeder......
 |
User Guide for HP J5730 / J5740 / J5750 / J5780 / J5785 / J5788Users also looked at:
If you use one of the following, setting the fax speed to a slower speed might be required...
If you experience problems sending and receiving faxes, you might want to try setting the Fax Speed setting to Medium or Slow......
v.29 (9600 baud...
Fax speed...
To set the fax speed from the control panel 1...Press 5, and then press 7...Press to select one of the following settings, and then press OK......
Medium...
v.34 (33600 baud...
Fast...
An Internet phone service A PBX system Fax over Internet Protocol (FoIP) An integrated services digital network (ISDN) service...
Slow...
You can set the fax speed used to communicate between the HP All-in-One and other fax machines when sending and receiving faxes...The default fax speed varies by country/ region......
Fax speed setting...
v.17 (14400 baud...
Ink is drying...
The rear door is off the HP All-in-One......
Transparencies and some other media require a drying time that is longer than normal......
Cannot load paper from input tray Ink is drying Out of paper Paper jam, misfeed or blocked carriage Paper mismatch Wrong paper width...
The print setting for the print job does not match the paper type or size loaded in the HP All-in-One......
Solution: Clear the jam......
Leave the sheet in the output tray until the message disappears...If it is necessary to remove the printed sheet before the message disappears, carefully hold the printed sheet on the underside or the edges, and place it on a flat surface to dry......
|