Entering the PIN code

Users also looked at:

To open the Installation menu (illustrated below), press... System Information 40... Time Zone... Input Configuration Channel Program Channel Add/Delete Channel Tuning Mode Signal Meter... Y on the remote control or TV control panel, open the... Time Zone Setup 40... System Status... Setup menu, select Installation, and press T...... Terrestrial...

From the Setup menu, highlight Installation and press T...A new set of Installation menu icons will appear...... You must configure the ANT/CABLE input source before programming channels (- left-hand column...... To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control...... Programming channels when the ANT/CABLE input is configured for Cable will take substantially longer than when the antenna input is configured for Antenna...This is normal; however, once channel programming is finished, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly......