Set Lock Code

This document also applies to:

JVC LT-42XM48

JVC LT-37XM48

JVC LT-37X688

Looking for a manual? Find it here...

Chapter Summary: Channel guard and V-Chip settings are protected by a four-digit lock code...You may change the code to any four-digit number you wish...To change the lock code, follow the steps below...... Initial Setup > Set Lock Code... To "Initial Setup" To enter To "Set Lock Code" To operate (Password input screen will appear... Lock Code 0 1 2 3... Set Clear... The Set Lock Code screen will appear... To set the password, use the 10 keypad...

User Guide for JVC LT-37X688 / LT-37XM48 / LT-42X688 / LT-42X788 / LT-42XM48 / LT-47X788

Users also looked at:

Page 63 - Back

This button allows you to go back in the menu to change a selection or correct a mistake......

Page 50 - Position Adjustment

To reset the adjustment to the center, press the OK button...When you change the screen size, perform the position adjustment again...When you are receiving a 1080p signal, Position Adjustment can not be selected...... To "Picture Adjust" To enter To "Position Adjustment" To enter To adjust the position Press the MENU button to finish... Operate OK Reset Back Back Menu Exit...

Page 55 - Photo Viewer

5) The TV screen will display a "hourglass" icon and then display the Photo Viewer Screen...... How to finish the Photo Viewer... Use the supplied USB cable that came with your device...Compatible file format is "Exif version 2.1, based on DCF version 1.0...Device" can only be selected when you have two or more devices connected to the TV...... JVC Everio Camera (Example... Photo Viewer allows you to enjoy your digital pictures stored on your USB Mass Storage Class devices...You are able to view them on this TV as high quality images......

This "User Guide" also applies to the following products: