User Guide for JVC LT-42XM48:
Set Clock
This document also applies to:
Chapter Summary:
The set clock function is described on page 23 as the Interactive Plug-in Menu...If you need to set the clock again, follow the steps below......
To "Clock/Timers" To enter To "Set Clock" To enter...
When you set the clock automatically, choose "Auto (Digital)" or "Auto (Analog)" by pressing the √or ® arrows......
Clock/Timers > Set Clock...
To "Channel" when you selected "Auto (Digital)" To select a receiving digital channel To "Time Zone" To select your time zone...
|
|
User Guide for JVC LT-37X688 / LT-37XM48 / LT-42X688 / LT-42X788 / LT-42XM48 / LT-47X788
Users also looked at:
To enter To "Auto Tuner Setup" To enter To choose "Cable" or "Air" To "Scan Mode...
Operate Back Exit...
Tuner Mode Scan Mode...
Air...
When the Tuner Mode is set to "Cable", it is possible to select "Scan Mode" • If no channels were found using Auto Tuner Setup, check your antenna cable and the settings for Tuner Mode/Scan Mode...You can also access the "Front Menu" screen by using the MENU button on the side of the TV instead of the remote control...Choose "Auto Tuner Setup" by pressing MENU† on the side panel and enter by using the CHANNEL +/- (√®) buttons......
To choose "Auto", "STD", "HRC" or "IRC" To "Start" Press the OK button (Programming will take serveral minutes...
The auto tuner is finished when the message "Programming Over !" appears onscreen......
To "Tuner Setup...
The auto tuner setup function is described on page 24 as the interactive plug-in menu...If you need to run the auto tuner setup again, follow the steps below......
|
This "User Guide" also applies to the following products:
