User Guide for JVC LT-32P679:
Programming Your Remote
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
You can program your remote control to operate your external devices, using the instructions and codes on pages 52 - 58......
How to set the codes...
1) Manually turn on the device...3) Find the remote control code for your device...4) Set the remote code......
The mode indicator goes out for a second, then it lights......
Press and hold Enter the four digit number...
5) Point the remote at the device and press power...If your device did not turn off or respond, try another code......
 |
User Guide for JVC LT-32P679Users also looked at:
This function automatically shuts off your TV when there is no signal from the channel while the TV is on for 10 minutes...On / Off...
High – Adjusts the effect maximally Low – Adjusts the effect minimally...
Sound Status Rock...
MTS Mono...
100Hz 8...
Surround OFF...
Audio Reset...
330Hz 4...
1KHz 5...
10KHz 5...
x 1...
fine tuned picture reproduction...Smart Picture adjusts the best possible picture quality automatically scene by scene based on the incoming signal from any source...
Aspect mode will show every pixel you are getting in High Definition...Full – with slight...
overscan...Panarama and Cinema will fill the screen with various aspect settings...Mini Mode will show a better picture with a smaller screen for low resolution content from your iPod......
TV sound quality...OmniSurround sound provides you 4 different settings based on the program you are watching...The equalizer will fine tune your listening preferences......
Full or Widescreen Mode – For high quality iPod sources......
|