User Guide for Panasonic AG-DVX100A:
Other types of problems
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
The cassette tape cannot be ejected......
Is power being supplied...Has the AC adapter been plugged in or the battery inserted properly...When the power is supplied, the cassette can be ejected without setting the POWER switch to ON......
Ejecting the cassette tape is the only operation which can be performed......
Has any condensation formed...Wait until the condensation dries up...If this does happen, slide the EJECT switch to open the cassette holder once again, then close the holder after ensuring that the cassette mechanism has completed the eject operation......
 |
User Guide for Panasonic AG-DVX100Users also looked at:
Internal microphone L...
CH2 (CH1) CH4 (CH3...
Input When shooting...
Inputs and audio tracks recorded...
INPUT 1 (XLR...
O If nothing has been recorded on the...
The audio tracks on which signals are to be recorded during shooting can be changed using the CH1 SELECT switch and CH2 SELECT switch...The audio tracks on which signals are to be recorded during audio dubbing can be changed using the A DUB INPUT item on the AV IN/OUT SETUP screen......
CH1 connector = CH2 signals CH2 connector = CH2 signals...
When audio dubbing (12-bit mode...
CH2 CH1 CH2...
CH1 CH3...
INPUT 2 (XLR...
12-bit AUDIO item and AUDIO OUT item settings, and audio tracks whose signals are output from the AUDIO IN/OUT connectors (pin jacks...
Notes...
AUDIO IN/OUT CH2 (pin jack...
BLANK...
The unrecorded blanks on the video tape are searched......
selected, the part which was shot last will not be searched when the tape is switched......
If the sound has been recorded in the 16-bit mode, there is no CH3 or CH4...Therefore, the correlation between the signals and tracks will always be as follows: CH1 signals = CH1 track CH2 signals = CH2 track...
CH1+CH3 CH2+CH4...
AUDIO IN/OUT CH2 output...
CH2 CH4...
|