Operation Manual for Sharp UX-B20:
Caller ID (Requires Subscription to Service)
This document also applies to:
Chapter Summary:
If you subscribe to a caller identification service from your telephone company, you can have the fax machine display the name and number of the caller when you receive a call......
To use this function, you must subscribe to a caller identification service from your telephone company...Note that your fax may not be compatible with some caller identification services......
This step is needed if your telephone exchange cannot...
|
|
Operation Manual for Sharp UX-B20
Users also looked at:
to clear the message and stop automatic redialing......
number dialed...Make sure the number that appears is the number you wish to dial......
date and time display......
B...
Press for EDIT or for CLEAR......
begin dialing...
If the transmission is completed successfully, the machine will beep once......
until the desired number...
When you hear the fax tone, press...
If you do not wish to change the name, go directly to Step 8......
or to move the cursor to the letter or letters you wish to...
1=EDIT, 2=CLEAR...
or an outside line, press...The pause will appear as a hyphen (two...
appears in the display, and then......
Redial...
change, and then enter the new digit...The new digit will replace the old digit......
If the transmission is unsuccessful and DOCUMENT JAMMED appears in the display, remove the document as explained on page 89...This may occur if the other fax machine doesn’t respond properly when you attempt to send the document...
|
This "Operation Manual" also applies to the following products:
