Operation Manual for Sharp UX-B20:
FCC Regulatory Information
This document also applies to:
Looking for a manual? Find it here...
Chapter Summary:
FCC Regulatory Information...
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA...On the rear of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX...If requested, this number must be provided to the telephone company......
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA...It is designed to be connected to a compatible modular jack that is also compliant...This equipment connects to the telephone network through a standard USOC RJ-11C network interface jack...
 |
Operation Manual for Sharp UX-B20Users also looked at:
If your area experiences a high incidence of lightning or power surges, we recommend that you install surge protectors for the power and telephone lines...Surge protectors can be purchased at most telephone specialty stores......
Connecting the Power Cord...
CHECK CARTRIDGE” normally appears in the display the first time you plug in the machine...This message appears until you install the print cartridge......
the machine and is not covered under the warranty......
Make sure you have removed all of the packing tape before plugging...
in the power cord (see page 10...Plugging in the power cord without doing so may damage the machine......
Plug the power cord into a 120 V, 60 Hz, grounded AC (3-prong) outlet......
The machine does not have a power on/off switch, so the power is turned on and off by simply plugging in or unplugging the power cord......
Do not plug the power cord into any other kind of outlet...This will damage...
Substitute Reception to Memory...
Automatic reduction may not be possible if the received document is too...
1=AUTO, 2=100...
Press to select AUTO, or to...
Press once and 5 times......
Fax Signal Receive...
Optional Reception Settings...
CALLER-ID...
if no name was stored, the number will appear......
completed...Check the "Note" column of the report to see if any of the destinations are marked "Busy" or have a communication error code...If so, send the document to those destinations again......
|