Operation Manual for Sharp UX-B20: 

Connecting the Telephone Line Cord

This document also applies to:


Looking for a manual? Find it here...


Chapter Summary: Connecting the Telephone Line Cord... Insert one end of the line cord into the jack on the back of the machine marked TEL...LINE...Insert the other end into a standard (RJ11C) single-line wall telephone jack...... Setting the dial mode... The fax machine is set for tone dialing...If you are on a pulse dial line, you must set the fax machine for pulse dialing...Press the panel keys as follows... Press once and 3 times......


Operation Manual for Sharp UX-B20

Users also looked at:

or clear the jam, or replace the print... erase all of the contents...... paper, be sure to add paper which is the same size as the paper previously used...If not, the document print-out size may not match the size of the printing paper...... In situations where printing is not possible, such as when the machine runs out of paper, the print cartridge needs replacement, or the paper jams, incoming faxes will be received to memory...... When you have received a document in memory, FAX RX IN MEMORY will appear in the display, alternating with ADD PAPER & PRESS START KEY, PAPER JAMMED, OUT OF INK, or PRINTER ERROR / CHECK PAPER... Substitute Reception to Memory... If you received documents in memory because the machine ran out of... cartridge, the stored documents will automatically print out...... When you add paper (and press... When documents are stored in memory, do not turn the power off...This will...

This "Operation Manual" also applies to the following products: