If you are seeing this message it means we are either still processing this manual or it's possible we just don't have it. Retrevo has hundreds of thousands of manuals covering over 80% of the products in our catalog and we add new manuals regularly. For the complete list please check out our manuals directory page here.
If anyone can help it would save me pulling the rest of my hair out..Thanks...I`m trying to keep this as short as I can ..so if I`ve missed out something..sorry...Never dial a connection is highlighted and though I HATE doing it I turned off the firewall=still the same result=very limited access saved pages mostly...
I figure it's because I haven't installed the drivers for it yet...With regards to downloading the driver you can go to www.2wire.com then click on support then drivers and documentation...Make sure that the gray cable is connected on a filter and on its correct port that says HPNA/DSL and it is connected where your dsl telephone number is...
1) can anyone tell me the full version number of the "sbc recovery_425" firmware discussed at length on another thread...2) I've tried configuring my 2700HG-B to drop the DSL connection after 10 minutes inactivity (seems pointless to keep the link up when it's not in use...Is there a way of reflashing the 2700HG-B with original firmware to get rid of any...
When I look at the device details for the slingbox it shows a 192.168.x.x IP address by when I look at the firewall settings I also see a public IP address that begins with a 63.x.x.x...The issue I have is that sometimes remotely it will be absolutely terrible, like 1 or 200k and I have 4 meg up! Just changed the router to virtual server rather than port forwarding & selected both tcp & udp and so...
I recently tried to get a Feisty installation running a Dynex card w/ no luck...So far, I can get the card connected to my network when I'm running an open, unencrypted network...When I try to use even the simplest encryption method on my 2Wire2700HG-B router, my wireless card will not connect to the network...