Calculated 44060 calculator
Product Support Information
http://www.calculated.com/
Table of contents
View All 
• INTRODUCTION
• KEY DEFINITIONS
• BASIC OPERATION KEYS
• Convert [Conv] Key—Unit Conversions and Second Functions
• Memory and Storage Functions
• Recall [Rcl] Key
• DIMENSIONAL MEASUREMENT UNIT KEYS
• WEIGHT KEYS
• Construction Project Keys
• Block/Brick Key
• Circular Function Keys
• Column/Cone Key
• Footing Key
• Right Triangle/Roof Framing Keys
• Hip/Valley and Jack Rafter Keys
• Rake Wall Function
• Roof Key
• Stair Key
• TRIGONOMETRY FUNCTION KEYS
• GETTING STARTED
• ENTERING DIMENSIONS
• Entering Linear Dimensions
• Entering Square/Cubic Dimensions
• CONVERSIONS (LINEAR, AREA, VOLUME)
• Linear Conversions
• Converting Feet-Inch-Fractions to Decimal Feet
• Converting Decimal Feet to Feet-Inch-Fractions
• Converting Fractional Inches to Decimal Inches
• Converting Decimal Inches to Fractional Inches
• Square Conversions
• Cubic Conversions
• PERFORMING BASIC MATH WITH DIMENSIONS
• Adding Dimensions
• Subtracting Dimensions
• Multiplying Dimensions
• Dividing Dimensions
• Percentage Calculations
• MEMORY OPERATION
• PAPERLESS TAPE OPERATION
• EXAMPLES — USING THE CONSTRUCTION
• LINEAR MEASUREMENT EXAMPLES
• Adding Linear Measurements
• Cutting Boards
• Window Measurement
• Calculating the Center Point
• AREA CALCULATIONS
• Square Area ( )
• Area of a Rectangular Room (LxW)
• VOLUME CALCULATIONS
• Rectangular Containers (LxWxH)
• Volume of a Cylinder
• Volume of a Cone
• WEIGHT/VOLUME CONVERSIONS
• Weight Conversions
• Weight per Volume/Volume Conversions
• BLOCKS/BRICKS
• Number of Blocks (not available on LT and Trig
• Number of Face Bricks (not available on LT and Trig
• Number of Paver Bricks (not available on LT and
• BOARD FEET — LUMBER ESTIMATION
• Total Board Feet — With Dollar Cost
• CIRCLE CALCULATIONS
• Circumference and Area of a Circle
• Circle Properties — Arc Length and Diameter Known
• Arched Windows
• Arc Length — Degree and Diameter Known
• Arc Length — Degree and Radius Known
• CONCRETE/PAVING
• Volume of Concrete for a Driveway
• Concrete Columns
• Complex Concrete Volume
• Concrete Footings (not available on Trig Plus III)
• Multiple Concrete Footings (not available on Trig Plus III)
• Squaring Up a Foundation
• FLOOR COVERING AREA CALCULATIONS
• Carpeting
• GRADE/SLOPE
• Back-Fill on a Slope — Percent of Grade Known
• ROOF FRAMING DEFINIT IONS
• Common Rafter Length
• Common Rafter Length — Pitch Unknown
• Angle and Diagonal (Hypotenuse)
• Rise
• Rise and Diagonal
• Finding Sheathing Cut
• Regular (45°) Hip/Valley and Jack Rafters (not avail- able...
• Jack Rafters — Using Other Than 16 Inch On-Center Spacing...
• Rake Wall – With Base
• ROOFING MATERIALS
• Roof Covering — Bundles of Roof Shingles (not available on...
• Roof Covering — Number of Shingles
• Area for Roofing Materials
• STAIR LAYOUT EXAMPLES
• STAIR LAYOUT DEFINIT IONS
• Stairs — Given Floor-to-Floor Rise
• Stairs — Given Rise and Run
• Stair Risers Only — Custom Height
• Baluster Spacing
• NUMBER OF STUDS
• TRIGONOMETRY AND D:M:S EXAMPLES
• PRACTICAL TRIGONOMETRIC FORMULAS
• Converting Degrees:Minutes:Seconds
• Time Calculations Using D:M:S
• Percent Grade/Slope
• Converting Tangent/Pitch to Angle
• Converting Roof Angle to Pitch
• Angle — Rise and Hypotenuse Known (Trig Plus III
• APPENDIX A — DEFAULT SETTINGS
• Metric Mode
• APPENDIX B — PREFERENCE SETTINGS
• How to Set Preferences
• LT (#4030)
• Handheld (#4060) and Desktop (#44060)
• Trig Plus III (#4075)
• APPENDIX C — USING THE DESKTOP PRINTING MODEL (DT Printer:...
• PRINTER KEYS
• CONNECTING THE AC ADAPTER
• USING BATTERY POWER
• REPLACING THE PAPER ROLL
• REPLACING THE INK ROLLER
• NOTES ON USING THE PRINTER
• APPENDIX E — ACCURACY, AUTO SHUT - OFF, BATTERIES, ERRORS
• Accuracy/Errors
• Auto Shut-Off
• Battery(ies)
• Replacing the Battery(ies)
• Battery Replacement Instructions
• Reset Key
• APPENDIX F — AREA/VOLUME FORMULAS
• REPAIR AND RETURN
• WARRANTY
View All
