http://www.directeddealers.com/...05-06.pdf
We hope you like our service. Recommend it to your friends.
Table of contents
View All 
• INTRODUCTION
• What’s in the Box
• IMPORTANT NOTE
• RECORD YOUR SERIAL NUMBER AND DATE
• END PANEL LAYOUTS
• CEA SPECIFICATIONS
• SPECIFICATIONS
• AMPLIFIER SETTINGS
• Signal Input and Output Configurations
• Input Gain
• Phase Switches
• Line Output Configurations (System Expansion)
• Internal Crossover Configurations
• Low-Pass Crossover
• High-Pass Crossover
• Fine Tuning the Crossovers
• Adjusting INTELLi
• Infinite Baffle Example High-Pass Set at 30Hz
• Sealed Example High-Pass Set at 20Hz
• Sealed Example High-Pass Set at 30Hz
• Vented Example High-Pass Set at 30Hz
• Remote Gain Operation
• AMPLIFIER WIRING
• Power Connections for the HCCA-D1200, and HCCA-D2400
• Power Connections for the HCCA-D5000
• Speaker Connections
• AMPLIFIER INSTALLATION
• Choosing Mounting Locations
• Passenger Compartment
• Trunk Compartment
• General Precautions and Installation Tips
• Tools of the Trade
• Step By Step Installation
• SET UP AND TROUBLESHOOTING
• Testing the System
• Adjusting the Sound of the System
• Troubleshooting Tips
• APPENDIX—PROGRAMMABLE FEATURES
• NOTES
View All
What subs will work with a Directed D2400 amp? - Yahoo! Answers
and he's running 1200w RMS and you think 4AWG wire will suffice...a guy from an audio shop recommended a pair of Pioneer champions they are 4ohm subs with a 400w RMS and 1200peak power handling...I'd run 2 memphis M3's dual 4 ohm subs, wire each sub to 2 ohms, then wire them together to one ohm, and keep in mind you need a good solid at least 4 guage wire for this amp, with a GOOD ground...
READ FULL ARTICLE »
