View All

• INTRODUCTION
• Inventory
• Hardware Recognition Chart
• Clean Up
• Site Considerations
• Moving & Placing Base Unit
• Mounting
• Table
• Blade Tracking
• Positive Stop
• Dust Collection
• Installing Fence
• Test Run
• Tensioning Blade
• Adjusting Support Bearings
• Adjusting Blade Guide Bearings
• Aligning Table
• Aligning Fence
• Miter Gauge
• SECTION 4: OPERATIONS
• Operation Safety
• Overview
• START/STOP Switch
• Guide Post
• Fine Tune Tracking
• Blade Lead
• Table Tilt
• Ripping
• Crosscutting
• Resawing
• Cutting Curves
• Stacked Cuts
• Blade Speed
• Blade Information
• Blade Changes
• SECTION 5: ACCESSORIES
• SECTION 6: MAINTENANCE
• Schedule
• Cleaning
• Unpainted Cast Iron
• Lubrication
• Wheel Brush
• SECTION 7: SERVICE
• Troubleshooting
• Checking V-Belt
• Tensioning V-Belt
• Replacing V-Belt
• Adjusting Tension Lever
• Adjusting Wheel Brush
• Wheel Alignment
• 513X Electrical Components
• 513X Wiring Diagram
• 514X Electrical Components
• 514X Wiring Diagram
• 514X3 Electrical Components
• 514X3 Wiring Diagram
• 513X Fence/Guide Parts
• 513X Parts List
• 513X Labels
• 514X/G0514X3 Fence/Guide Parts
• 514X/G0514X3 Labels
• 514X/G0514X3 Parts List
• WARRANTY AND RETURNS
View All
