SpectraLink MCS300 telephone
Product Support Information
http://www.spectralink.com/
Table of contents
View All 
• About This Document
• SpectraLink Corporation Model Numbers
• Related Documents
• Contacting SpectraLink
• Icons and Conventions
• Troubleshooting Overview
• System Maintenance
• Replace an Interface Module (Hot Swap)
• Add a Handset
• Replace a Handset
• Delete a Handset
• Add a Base Station
• Delete a Base Station
• Add a Shelf
• Delete a Shelf
• Handset Problems
• Using the Handsets
• No Extension/Wrong Extension Displayed
• No Svc Displayed
• No Dialtone / No Audio
• No Handoff
• Calls Ring on the Wrong Handset
• Multiple Handsets Not Working
• Base Station Problems
• Multiple Base Stations Not Working
• Base Station LED Not Lit
• Base Station LED Flashing Red and Green
• Base Station Disabled
• Base Station Will Not Download
• Base Station LED Flashing Red
• Base Station LED Solid Red or Yellow
• Base Station LED Flashing Red, Yellow, Green
• Troubleshooting During Start-Up Phase
• Boot ROM LEDs
• Boot ROM Alarms
• Downloads
• Configuration Changes
• Troubleshooting Card Alarms
• System and Shelf Controller Card Status Indicators
• Interface Module Status LEDs
• Reading the Status LEDs
• LED and Alarm Troubleshooting Tables
• System Controller Card Alarm Matrix
• System Controller Card Troubleshooting Matrix
• Shelf Controller Card Alarms
• Shelf Controller Card Troubleshooting Matrix
• Interface Module Alarm Matrix
• Interface Module Troubleshooting Matrix
• Alarms
• Terms and Acronyms
View All
http://www.spectralink.com/
Table of contents
• Introduction
• FCC Certification
• Industry Canada (IC) Notice
• European Union Directives Conformance Statement
http://www.spectralink.com/
Table of contents
View All
• About This Document
• SpectraLink Corporation Model Numbers
• Related Documents
• Customer Support Hotline
• Icons and Conventions
• Install the Console
• Connect Console to MCU
• Install Software
• Navigating within the Operator’s Console
• Port Location
• Main Menu
• System Configuration
• Configure Interface Modules (Port Cards) (F4-Portcard...
• Configure MCU (F8-Configuration Display and Administration)
• Program MCU Macros (F6-MCU Macros Display)
• Program Telephone Menus (F9-PT Menu Administration)
• Program COM Ports (F10-COM Port Administration)
• System Status
• Supervisor State Display (F1)
• Remote Card Options
• Portcard State Display(F2)
• Hiway State Display (F3)
• System Activity and Alarm Display (F5)
• Diagnostic Procedures
• Listen Verify Test
• Backups
• Dump Config to Disk
• Restore Config
• Alarms
View All
http://www.spectralink.com/
Table of contents
View All
• About This Document
• SpectraLink Corporation Model Numbers
• Related Documents
• Contacting SpectraLink
• Icons Used in this Document
• Installation Overview
• Link Wireless Telephone System Description
• Link Wireless Telephone System Components
• The Master Control Unit
• Base Stations
• Link Wireless Telephones
• Operator’s Console
• Site Preparation
• Required Materials Provided by Customer
• Prepare Location for Shelves
• Prepare Power for Shelves
• Run Cables to Base Station Locations
• Terminate Cables at Base Station Locations
• Prepare Demarc Blocks
• Install Demarc Blocks
• Program Telephone System
• Connect Cables from Base Stations and Phone Lines to Demarc...
• System Installation
• Facility Analysis
• Check Components
• Install Shelves
• Install Intershelf Junction Panel
• Connect Power to Shelves
• Install Cards
• Connect the Intershelf Junction Panel
• Connect Demarc Block RJ-21 Cables to Interface Modules
• Install Base Stations
• Mount Base Stations on Dropped Tile Ceilings
• Mount Base Stations On Finished Ceilings
• Install Outdoor Base Stations
• Power Up and Check Diagnostics
• System Initialization
• Test System
• Voice-test each Base Station
• Run Listen Verify Diagnostic
• Site Certification
• Installation Forms
• Site Preparation Checklist
• Base Station Location Form
• Extension Assignments Worksheet
• Customer Acceptance Form
View All
